Product description

1st Dual socket R (LGA 2011) Supports Intel® Xeon® processor E5-2600 second C602J Intel® chipset; QPI up to 8.0GT / s up to 768 gigabytes third 1600MHz DDR3 ECC Registered DIMM *; 24x DIMM sockets * Depends on memory configuration 4th Expansion Slots: 2 PCI-E x16 3.0 and 4 x8 PCI-E 3.0, fifth Intel® X540 Dual Port 10GBase-T sixth 4x SATA2 and SATA3 ports 2x 7th Integrated IPMI 2.0 and KVM with Dedicated LAN eighth 8x USB 2.0 ports (4 rear, 2 via header 2 Type A) Physical Stats Form Factor Enhanced E-ATX Dimensions 13.68 "x 13" (34.7 cm x 33 cm) Processor / Cache CPU Intel® Xeon® processor E5-2600 (up to 135W TDP **) Dual Socket R (LGA 2011) Up to 20 megabytes Cache System Bus QPI up to 8 GT / s ** Motherboard Supports this maximum TDP. Please verify your system Can thermally support. System Memory Memory Capacity 24x 240-pin DDR3 DIMM sockets Supports up to 768 gigabytes of DDR3 ECC Registered memory (RDIMMs) in 24 DIMM sockets Supports up to 128 gigabytes DDR3 ECC / non-ECC Un-Buffered memory (UDIMM) in 24 DIMM sockets Memory Type 1600/1333/1066 / 800MHz ECC DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMsSupport ECC and non-ECC UDIMMs DIMM Sizes 32GB 16GB 8GB, 4GB, 2GB 1 gigabyte Memory Voltage 1.5 V, 1.35 V Error Detection corrects single-bit errors Detects double-bit errors (using ECC memory) On-Board Devices Chipset Intel® chipset C602J SATA 3Gbps SATA 2.0 with RAID 0, 1, 5, 10 SATA 3.0 6Gbps with RAID 0, 1, 5, 10 IPMI Support for Intelligent Platform Management Interface v.2.0 IPMI 2.0 with virtual media over LAN and KVM-over-LAN support WPCM450 Nuvoton BMC Network Controllers Intel® X540 Dual Port 10GBase-T Virtual Machine Device Queues reduce I / O overhead Supports 10GBase-T, 100BASE-TX, 1000BASE-T and, 1x RJ45 output Realtek PHY RTL8201N (dedicated IPMI) Video G200 (Nuvoton BMC WPCM450 with graphic controller) Super I / O Nuvoton W83527HG Input / Output SATA 2 ports SATA 3.0 (6Gbps) 4 SATA 2.0 ports (3Gbps) 2 RJ45 LAN 10GBase-T ports 1 RJ45 Dedicated IPMI LAN port USB 8 USB 2.0 ports total (4 rear 2 via header 2 Type A), 1 VGA port Video Keyboard / Mouse PS / 2 Keyboard / Mouse port Serial Port / Header 2 Fast UART 16550 ports: 1 rear and 1 header DOM 1 DOM (Disk on Module) power connector TPM TPM 1.2 1 20-pin Header Chassis (Optimized for X9DRE-TF) 2U Chassis CSE-826BA-R1K28LPB CSE-826BA-R920LPB CSE -826BE16-R1K28LPB CSE-826BE16-R920LPB CSE-826BE26-R1K28LPB CSE-826BE26-R920LPB CSE-828TQ-R1K43LPB 3U Chassis CSE-835BTQ-R1K28B CSE-835TQ-R920B CSE-836BA-R1K28B CSE-836BE16-R1K28B CSE-836BE26- R1K28B Important Chassis Notes To support the new generation Intel® Xeon® processor-based motherboards, Revision M chassis is recommended. Please talk to your sales representative for details. Please use optional I / O shield MCP-260-00041-0N in Supermicro 1U chassis Expansion Slots 2 PCI-Express (x16) PCI-E 3.0 slots 4 (x8) PCI-E 3.0 slots (Both CPUs need to be Installed for full access to PCI-E slots and onboard controllers. See manual block diagram for details.) System BIOS BIOS Type 128Mb SPI Flash EEPROM with AMI BIOS BIOS Features Plug and Play (PnP) APM 1.2 PCI 2.3 ACPI 1.0 / 2.0 / 3.0 / 4.0 USB Keyboard support SMBIOS 2.7.1UEFI Management Software IPMI (Intelligent Platform Management Interface) v1.5 / 2.0 with KVM support SuperDoctor® III Watch Dog NMI Optional IPMI 1.5 / 2.0 Power Configurations ACPI / APM Power Management Main Switch Override Mechanism CPU Fan auto-off in sleep mode Power-on mode for AC power recovery PC Health Monitoring Voltage Monitors for CPU Cores, 1.8V, 3.3V, 5V, ± 12V, 3.3V Standby, Standby 5V, VBAT, HT, Memory, Chipset Voltages. 5 Phase-switching voltage regulator FAN 8x 4-pin fan headers (up to 8 fans) 8x fans with tachometer monitoring Status monitor for speed control Status monitor for on / off control Low noise fan speed control Pulse Width Modulated (PWM) fan connectors Temperature Monitoring for CPU and chassis environment CPU thermal trip support Thermal Control for 8x Fan Connectors I2C temperature sensing logic Thermal Monitor 2 (TM2) support PECI LED CPU / System Overheat LED Other Features Chassis intrusion detection Chassis intrusion header SDDC Support Operating Environment Operating Temperature Range 10 ° C - 35 ° C (50 ° F - 95 ° F) Non-Operating Temperature Range -40 ° C - 70 ° C (-40 ° F - 158 ° F) Operating Relative Humidity Range 8% - 90% (non- condensing) Non-Operating Relative Humidity Range